Headlights

[01tireshredder]

OK, so everyone knows what I have for the most part. An '01, QCSB 24 valve with the VP 44. It is built to the point that anything else will mean milling the intake & p=pumping it. So, I have a new problem. My brights do not work now. The only thing I can come up with is either the main switch, or the multi function switch. Any input will be looked at & checked out to a T. Thanks all in advance.

[Kilch123]

is this with the new lights, or your original ones?

[04cumminsram]

did you flip the switch right? 

 





 

[01tireshredder]

did you flip the switch right? 

 





 

Jackass, you know because you drove it like this.

Tom, this has been going on since the build. I must add that I put in one of the relay kits from Geno's about 6 months ago. It does it still with the factory hookup with the originals. I must also add that the new lights are 150% brighter than the old.

[Kilch123]

Look at post number 4 in this thread - check your wiring

http://www.dodgeforum.com/forum/2nd-gen-ram/179310-headlight-wiring-harness.html

I posted a different link for someone else recently, but can't find the post...

It's possible that the ground/high beam wire needs to be reversed

[01tireshredder]

Got the headlights working. Also found the elusive short  that was created from pulling excessive wire out of the old girl from previous excursions. Kudos to Tom  for his time on the phone & several emails in figuring this PITA out. Get the dash back together tomorrow & she will be ready to roll again.