2007 Dodge Caliber and Transmission Speed Sensor

[[email protected]]

The Vehicle has thrown error code u4112 and will not start.  Would a transmission speed sensor cause the vehicle to not start?

[JetNoise]

I am not seeing any information about that particular code, but what I can find about "U" codes, they are all computer errors. I would say that your computer will definitely keep your car from starting.

From my experience, the "P" codes would cover things like a speed sensor, so I wouldn't say that the sensor is your issue.

[[email protected]]

Sorry, I put the wrong code in.  It is actually u1412.  Here is some more information:
DTC for which Freeze Frame was Stored    U1412
Fuel System 1 Status    Open Loop
Fuel System 2 Status    Not Supported
Calculated LOAD Value    100.00 %
Engine Coolant Temp    53.60 °F
Short Term Fuel Trim - Bank 1    0.00 %
Long Term Fuel Trim - Bank 1    0.00 %
Intake Manifold Absolute Pressure    27.83 inHg
Engine RPM    145.00 rpm
Vehicle Speed Sensor    37.28 mph
Ignition Timing Advance #1 Cylinder    5.00 °
Intake Air Temperature    57.20 °F
Absolute Throttle Position    16.08 %
Time Since Engine Start    0 sec
Commanded Evaporative Purge    1.96 %
Fuel Level Input    34.51 %
Barometric Pressure    28.72 inHg
Control Module Voltage    8.36 V
Absolute Load Value    83.92 %
Commanded Equivalence Ratio    1.00
Relative Throttle Position    6.67 %
Ambient Air Temperature    60.80 °F
Absolute Throttle Position B    15.69 %
Accelerator Pedal Position D    18.04 %
Accelerator Pedal Position E    9.02 %
Commanded Throttle Actuator    8.24 %