Gauge pictures and setups

[Kilch123]

damn!  that's quick to failure - they have a warranty?

[noplugs]

Tom, didnt you get some new gauges?

[Kilch123]

yes - i got the same as you have

I'm just surprised his only lasted 6 months

[georgeshannon]

damn!  that's quick to failure - they have a warranty?

They have a 1 year warranty. Doubt I'll mess with it though. 99% of the time I drive during the day when that light is not noticible. Would prefer to have the gauge than a hole in the pod.

So what is that light? LED? Grain-of-wheat bulb?

Think I'd get more enjoyment doing a failure analysis than having a new gauge.

[georgeshannon]

Just noticed today the needle light flickered. Must be an intermittant connection or a loose filiment.

[Motorbrreath]

isspros. trans temp, boost, egt

[BC847]

The typical ISSPRO 4K tach on the column . . .  .





And then ISSPRO Trans Temperature, Fuel Pressure, EGT, and 100psig Boost gauges. All have the single push-button Total-Recall feature and are part of the DATA-logging system. Additional sensors include Fuel Temperature, Primary Turbo Boost, Turbo Drive Pressure, etc. . ..




 

[Mitch]

That is a nice looking setup BC. I like the in dash plate.

[dragonslayer169]

I like the setup you have done with the indash plat BC. Good job! It looks very clean

[Motorbrreath]

where did you get the steering cover mount?!

hook a brother up with that

[BC847]

where did you get the steering cover mount?!

hook a brother up with that

http://www.genosgarage.com/prodinfo.asp?number=GM-DG-15012
http://www.statracing.com/buy/autometer/pn/15012.asp

Most of the 2nd gen column mounts will fit the '91~'93 1st gen trucks WITH the tilt-wheel option.

Hope this helps.

While you're in there, you might consider also upgrading the column shifter to the 2nd gen version that includes the Over-Drive button in the shifter's handle.  It's a little more convenient than that button on the dash.

[Motorbrreath]

where did you get the steering cover mount?!

hook a brother up with that

http://www.genosgarage.com/prodinfo.asp?number=GM-DG-15012
http://www.statracing.com/buy/autometer/pn/15012.asp

Most of the 2nd gen column mounts will fit the '91~'93 1st gen trucks WITH the tilt-wheel option.

Hope this helps.

While you're in there, you might consider also upgrading the column shifter to the 2nd gen version that includes the Over-Drive button in the shifter's handle.  It's a little more convenient than that button on the dash.

i had thought they would, but i thought the hazard switch was different. good to know!

[mayfair]

That looks fuggin AWESOME!!

[lilfroger]

Need to update since I moved the trans temp

Isspro EGT, Boost, Fuel Pressure (top to bottom) at night:


Isspro EGT, Boost, Fuel Pressure (top to bottom) during day:


Isspro Trans Temp on dash:

[Mitch]

382 miles and you are on E? Holy crap that is terrible. I thought my mileage was terrible.