Here is the parts list:
2ea. #4411 lights from Napa (auto quest also uses the same part numbers) - the lights in my pictures are actually from a Semi service place locally cause we broke one of the 4411 lights on install.
2 4 inch rubber light grommets
1 relay, one three position switch
2 wire splices, 8 ring style crimp connectors (1/4 inch hole)
8 insulated female spade connectors
a roll of red wire and a roll of black wire.
Here is a wiring diagram on how to tie into the reverse lights w/ a 3 way switch
Measure for location on the bumper (and then remeasure...drink a beer and measure a 3rd time)
Once marked using a 4" 1/4" whole saw on a STRONG drill with plenty of cutting lubricate cut the bumper
Insert rubber grommet and light
Run power wire from light to fuse panel. I used red for obvious reasons and added the extra insurance of a wire-loom to protect the wire.
each light is independently grounded to frame
Mount switch in convent location
We choice not to run our lights on a 3-way switch but with a simple on / off. Grounded switch to dash and ran hot to battery
End Results:
with OUT lights on:
WITH lights on: